Инструкции Пользователя для Hitachi DZ-MV780A

English

While holding down the gray button at the right 
of power switch, set the switch according to 
each recording function:

Power ON status

During playback, set the power switch to “O” 
or “N” when using disc, or set it to “P” when 
using card.
Turn the switch while holding down the gray 
button at the right of switch.

• Once you turn the DVD video camera/recorder on to 

let it recognize the disc, you can immediately record 
or play back by turning the DVD video camera/
recorder on again. However, if a long time has 
elapsed after the disc was inserted, it will take some 
time for the DVD video camera/recorder to start 
because it must recognize the disc again (see 
page 158).

• It will take some time for the DVD video camera/

recorder to display the Disc Navigation screen after 
power is turned on.

• If you turn the DVD video camera/recorder on, the 

ACCESS indicator will light or blink to show that the 
DVD video camera/recorder is recognizing the disc or 
card: During this time, no operation, such as 
recording, can be performed.
After several seconds, the ACCESS indicator will go 
out, and operating the DVD video camera/recorder 
will be possible.
If the ACCESS indicator does not go out, refer to 
“Check 4” on page 158.

• When the DVD video camera/recorder is turned on, 

the self-diagnosis function will work and a message 
may appear. In this case, refer to “Trouble Messages” 
on page 160 and take corrective action.

• While the ACCESS/PC or CARD ACCESS indicator is 

lit or blinking, do not violently open or close the LCD 
monitor.

The DVD video camera/
recorder will turn off.

P

To record still on SD 
memory card

O

To record movie on DVD-
RAM or DVD-R disc

N

To record still on DVD-
RAM disc

OFF

OFF

Power switch

ACCESS/PC 
indicator