Руководство Пользователя для Clavia lead 3
5. Morph groups: Assign parameters to a Morph group
NORD LEAD 3 V1.2x
Page 30
3. Turn the parameter K
NOBS
you want to assign to the Morph group. The first and last LED of the
Morph range will light up. A Morph range can be either negative or positive according to your
choice. The “zero” Morph value is the parameter’s initial setting.
choice. The “zero” Morph value is the parameter’s initial setting.
1. As soon as you assign the first parameter in a Morph group the green LED above the M
ORPH
A
SSIGN
button will light up to indicate that the Morph group is now active.
If you want to see all the parameters’ initial settings again, just release the M
ORPH
A
SSIGN
button and
the LED graphs will light up again to show the settings. To continue the Morph assignment, press
the M
the M
ORPH
A
SSIGN
button again.
To change the initial parameter value(s) and thus move the entire Morph range (sector), just change
the parameter value without pressing the M
the parameter value without pressing the M
ORPH
A
SSIGN
button (just as you would change an unas-
signed parameter).
The Wheel and Aftertouch/Pedal Morphs will show the actual parameter values when you change the
source value. The Velocity and Keyboard Morphs don’t show the actual parameter values as you play
on the keyboard. It’s made this way because it gets irritating after a while to watch all flickering LEDs
as you play. However, if you press and hold the M
source value. The Velocity and Keyboard Morphs don’t show the actual parameter values as you play
on the keyboard. It’s made this way because it gets irritating after a while to watch all flickering LEDs
as you play. However, if you press and hold the M
ONITOR
/C
OPY
button and play the keyboard you
can view the Velocity and Keyboard morphs as well.
Note: If you have assigned the same parameter to several Morph groups and control the parameter si-
multaneously from the different Morph group control sources, the parameter values will be added This
means that the parameter value can go beyond the ranges set for each individual Morph group.
multaneously from the different Morph group control sources, the parameter values will be added This
means that the parameter value can go beyond the ranges set for each individual Morph group.
Tip! If you want to enter Morph Assign mode without needing to hold the M
ORPH
A
SSIGN
button
you can double-click the M
ORPH
A
SSIGN
button. Click again to exit Morph Assign mode.