Руководство По Настройке для Canon B150

❏ Cannot receive a document automatically?

• Is the fax set to receive automatically?

For the fax to receive automatically, the LCD must display “Fax/Tel”,
“Fax Only” or “AnsMode”. Press [RECEIVE MODE] to display “Fax/
Tel Mode”“Fax Only Mode”or “Ans. Machine Mode”  on the operation
panel. See pp. 69, 70.

• Make sure you have printed out any document received in memory. See p. 72.
• Check the LCD for an error message. See p. 110.
• Print an activity report and look for an error code. See pp. 87, 110.

❏ The fax won’t switch automatically between telephone and fax

• Is “Fax/Tel” displayed on the LCD?

For the fax to switch automatically between telephone and fax reception,
“Fax/Tel” must be displayed on the LCD. Press [RECEIVE MODE] on
the operation panel to select “Fax/Tel Mode”. See p. 69.

• Make sure you have printed out any documents in memory. See p. 72.
• Check the LCD for an error message. See p. 110.
• Some fax units cannot send the CNG signal that tells your fax the incom-

ing signal is from a fax. In such cases, you will have to receive the
document manually.

❏ Cannot receive a document manually?

• Is an extension phone connected to your fax?

You cannot receive manually unless an extension phone is connected.

• Is a document fed into the fax?

Remove the document. You cannot receive when there is a document fed
into your fax.

• Did you press [START/COPY] after hanging up the handset?

Always press [START/COPY] before hanging up the handset. Don’t
press [START/COPY] after you hang up the handset.

❏ Print quality poor?

• Are you using the correct type of paper?

Be sure you are using paper that meets the paper requirements for this
fax. See p. 7.

• Is the fax unit’s BJ cartridge out of ink?

Replace the BJ cartridge. See p. 103.

• Make a copy on your fax. If the image is OK, then your fax is operating

properly.
Contact the other party and have them check their machine.