Инструкция С Настройками для Canon 10

114

Using a Memory Card

(ELURA20 MC only)

4. Select the desired setting.

• Your currently recording image is combined with the pre-recorded still

image.

5. Select MIX LEVEL.

6. Adjust the mix level.

• Turning the SELECT dial upwards adjusts to the right and turning

downwards adjusts to the left.

7. Close the menu.

• CARD MIX flashes in the display.

8. Press the card MIX button.

• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still

image.

• Each time you press the card MIX button, your selection is activated

(display lights continuously) or deactivated (display flashes).

1. Press the start/stop button to start and stop recording.

• The combined images are recorded onto the cassette.

1. Press the PHOTO button halfway down and hold it.

•

F flashes white in the display as the camera adjusts the focus and it is
displayed continuously as a green mark when the camera is ready to take the
image.

2. Press the PHOTO button fully down to record the image to the

cassette.

•

F disappears from the display.

• The combined images are recorded onto the cassette for approximately 6

seconds (8 seconds in the

SP or

LP recording mode).

• You cannot use Card Mix in the Low Light recording program (in MOVIE and

P.SCAN modes).

• If you change the position of the POWER dial or move the program selector

from

[ Easy Recording mode, select your still image for Card Mix

again.

• When setting Card Mix, you must carry out steps 1 to 5.

For a still image

For a moving image

On/Off