Инструкция С Настройками для Canon 10

• If the subject is unsuitable for autofocus (

130), the camera may not be

able to focus, and 

F may continue to flash white in the display. Continue to

hold the PHOTO button halfway down, then adjust the focus manually with
the SELECT dial.

• If you are using manual focus (

72), the 

F mark starts as a continous

green mark. Focus with the SELECT dial.

• The camera takes the image immediately, and then records the “photo” to

the tape for approximately 6 seconds*. During this time the camera also
records the sound, and the display shows the still picture.

• A counter display appears, and counts up as the camcorder records the

picture.

F disappears from the display.

• The camera returns to record pause mode.

• The camera automatically returns to record pause mode after recording a still

image for approximately 6 seconds*. If you turn the POWER dial to OFF
during that time, the camcorder will respond only after recording is complete.

• The wireless controller’s PHOTO button has no half-way setting. Press the

button fully and the camera immediately takes the “photo”.

• Only take “photos” where it is bright enough to see the image in the display.
• If you want to use an effect, make sure you set it before you take your picture.

*8 seconds in 

SP or 

LP recording mode.