Руководство Пользователя для LXE mx3
144
Symbol Barcodes
Integrated Scanner Programming Guide
E-SW-SCANNERPG-L
SE955 only
Enable 978
Supplemental
Mode
Enable 978
Supplemental
Mode
The scanner will identify supplementals for
EAN-13 barcodes that start with a 978 prefix
only. All other UPC/EAN codes are decoded
immediately and the supplemental characters
ignored.
EAN-13 barcodes that start with a 978 prefix
only. All other UPC/EAN codes are decoded
immediately and the supplemental characters
ignored.
978 Supplemental Mode
SE955 only
Enable Smart
Supplemental
Mode
Enable Smart
Supplemental
Mode
The scanner will identify supplementals for
EAN-13 barcodes that start with a 378, 379 or
978 prefix only. All other UPC/EAN codes are
decoded immediately and the supplemental
characters ignored.
EAN-13 barcodes that start with a 378, 379 or
978 prefix only. All other UPC/EAN codes are
decoded immediately and the supplemental
characters ignored.
Smart Supplemental Mode
Decode UPC/EAN Supplemental Redundancy
Parameter Default Value:
SE2223 : 20 Times
Others: 7 Times
With Autodiscriminate UPC/EAN Supplementals selected, this option adjusts the number of times a
symbol without supplementals will be decoded before transmission. The range is from 2 to 20 times.
Five or above is recommended when decoding a mix of UPC/EAN symbols with and without
supplementals, and the autodiscriminate option is selected.
symbol without supplementals will be decoded before transmission. The range is from 2 to 20 times.
Five or above is recommended when decoding a mix of UPC/EAN symbols with and without
supplementals, and the autodiscriminate option is selected.
To begin setting the decode redundancy value, scan this barcode:
Decode Supplemental Redunda
Next, scan two numeric barcodes that correspond to the desired value using the “Keypad Number
Symbols” at the end of this chapter. Single digit numbers must have a leading zero.
Symbols” at the end of this chapter. Single digit numbers must have a leading zero.
If you wish to change your selection, scan Cancel on the “Keypad Number Symbols” page.