Руководство Пользователя для LXE mx3
5380SF 2D Imager - Imager Parameters – General
229
E-SW-SCANNERPG-L
Integrated Scanner Programming Guide
Reread Delay
Parameter Default Values:
Reread Delay
Medium (750 ms)
User-Specified Delay
Medium (750 ms) / Range: Min: 0 ms / Max: 30,000
ms
ms
Short (500 ms)
Medium (750 ms)
Long (1000 ms)
Extra Long (2000 ms)
Scan one of the barcodes above to set the time period before the imager can read the same barcode a
second time. Setting a reread delay may protect against accidental rereads of the same barcode. Use
shorter delays in applications where repetitive barcode scanning is required.
second time. Setting a reread delay may protect against accidental rereads of the same barcode. Use
shorter delays in applications where repetitive barcode scanning is required.
User Specified Reread Delay
Parameter Default Value:
Medium (750 ms) / Range: Minimum 0 ms / Maximum
30,000 milliseconds
30,000 milliseconds
User-Specified Reread Delay
If the barcodes available in section titled “Reread Delay” are insufficient, you can set the amount of
time before the imager can read the same barcode using the User-Specified Reread Delay barcode.
time before the imager can read the same barcode using the User-Specified Reread Delay barcode.
Scan the User-Specified Reread Delay barcode, then scan up to 5 digits in a row using the number
symbols on the “Symbols 0-9” page at the end of this chapter, then scan Save. If you make an error
while scanning the digits (before scanning Save), scan the Discard barcode, then scan the User-
Specified Reread Delay barcode, scan the correct digits, and then scan the Save barcode again.
symbols on the “Symbols 0-9” page at the end of this chapter, then scan Save. If you make an error
while scanning the digits (before scanning Save), scan the Discard barcode, then scan the User-
Specified Reread Delay barcode, scan the correct digits, and then scan the Save barcode again.