Руководство Пользователя для LXE mx3
Symbol Barcodes - Scanner Parameters – General
65
E-SW-SCANNERPG-L
Integrated Scanner Programming Guide
Set Default Parameter
Scanner:
2223 1524 1224 1223 923 824
Use the Set Default parameter to reset
all
scanner parameters to their default values. See the “Pre-
Configured Default Settings” list in the Quick Start section earlier in this chapter.
Note: Scanning the Cancel barcode will not undo a Set Default scan.
Set All Defaults
Important
When all parameters are reset to the default values, you must again set the Laser On Time parameter
to 1.5 sec to match a device-specific default Max On Timer default value of 1.5 sec.
to 1.5 sec to match a device-specific default Max On Timer default value of 1.5 sec.
Parameter
Default Value for SE2223
All Others
Laser On Time
5.0 sec
3.0 sec
Scanner:
955
Restore Defaults
If custom defaults were set by scanning Write Custom Defaults, scan Restore Defaults to retrieve and
restore the scanner’s custom default settings. If no custom defaults were set, scan Restore Defaults to
restore the factory default values.
restore the scanner’s custom default settings. If no custom defaults were set, scan Restore Defaults to
restore the factory default values.
Set Factory Defaults
Restore the factory default values. If custom defaults were set, they are eliminated.
Write Custom Defaults
Store the current scanner settings as custom defaults. Once custom default settings are stored, they
can be recovered at any time by scanning the Restore Defaults barcode.
can be recovered at any time by scanning the Restore Defaults barcode.
Restore Defaults
Set Factory Defaul
Write Custom Defa