Дополнительное Руководство для Ricoh AP610N
G1128611A_1.10
Copyright ©
2004, 2005
75
Troubleshooting
Error & Status Messages on the Control
Panel
Panel
This section explains what the messages that appear on the control panel mean
and what to do when a particular message appears.
and what to do when a particular message appears.
❖ Messages (in alphabetical order)
Messages/Second
messages
Description
Solution
Call Service: EC
Power Off On
/ If Error Reoccur
Call Service
An error A communication error
sent from the engine to the con-
troller has occurred in the print-
er.
sent from the engine to the con-
troller has occurred in the print-
er.
Turn the power off, and then on. If the
message appears again, call your
sales or service representative.
message appears again, call your
sales or service representative.
Cannot check
Signal in Ad hoc
An attempt to check the radio
signal was made while the
communication mode was set
to [802.11 Ad hoc] in the interface
settings.
signal was made while the
communication mode was set
to [802.11 Ad hoc] in the interface
settings.
To check the radio signal , select In-
frastructure in the communication
mode settings.
frastructure in the communication
mode settings.
Change Setting
Tray #
/ Paper Size:
Paper Type:
The paper size and type setting
in the tray differs from that of
actual paper size and type in
the tray.
in the tray differs from that of
actual paper size and type in
the tray.
#: tray number
Load paper of the selected size in the
tray, and then change the paper size
setting with the control panel. Or,
press {Form Feed}, and then select the
tray using the control panel. Or, press
{Job Reset} to cancel the print job.
tray, and then change the paper size
setting with the control panel. Or,
press {Form Feed}, and then select the
tray using the control panel. Or, press
{Job Reset} to cancel the print job.
You can make to setting to print disre-
garding the error message.
garding the error message.
Close Duplex
Unit Cover
The cover of the optional du-
plex unit is open.
plex unit is open.
Close the cover of the optional duplex
unit.
unit.
Close
Front Cover
The front cover is open.
Close the front cover.
Close Rear/Paper
Exit Cover
The paper exit cover or the rear
cover is open.
cover is open.
Close the paper exit cover or the rear
cover.
cover.
Collate Cancelled
The collate feature has been
cancelled.
cancelled.
Increase the RAM capacity.
DHCP assigned
Cannot change
An attempt to change the IP ad-
dress, subnet mask or gateway
address was made while DHCP
was set to [On].
dress, subnet mask or gateway
address was made while DHCP
was set to [On].
Make the change after setting DHCP
to [Off].
to [Off].
Driver Setting
Error (Memory)
The printer identified a down-
load error. This error may occur
when the installed memory
amount is less than the driver
setting.
load error. This error may occur
when the installed memory
amount is less than the driver
setting.
Verify that the proper memory size is
specified via the driver setting.
specified via the driver setting.