Руководство По Программному Обеспечению для Ricoh ap900

Monitoring and Configuring the Printer

206

set

Use the “set” command to set the protocol information display “active” or “inac-
tive”.

❖ View settings

The following command displays protocol information (active/inactive).

msh> set tcpip

msh> set appletalk

msh> set netware

msh> set smb

msh> set scsiprint

• scsiprint is available when the optional IEEE 1394 interface board is in-

stalled.

msh> set ip1394

• ip1394 can be specified only when the IEEE 1394 interface is installed.

msh> set protocol

• When protocol is specified, information about TCP/IP, appletalk, netware,

and smb appears.

msh> set lpr

msh> set ftp

msh> set rsh

msh> set diprint

msh> set web

msh> set snmp

msh> set ssl

msh> set nrs

msh> set rfu

msh> set ipp

msh> set http

msh> set rendezvous

❖ Configuration

• Enter “up”to enable protocol, and enter “down” to disable protocol.
You can set the protocol to “active” or “inactive”.

msh> set tcpip {up | down}

• If you disable TCP/IP, you cannot use remote access after logging off. If

you did this by mistake, you can use the control panel to enable remote ac-
cess via TCP/IP.