Руководство Пользователя для Clover cdr-4010
- 45 -
Up to total 2 HDD can be used in this system.
Fig. 9-1 System In
9.2 Installation of an additional HDD
Turn off the power. Unscrew and remove the cover.
In a two hard drive system, the drives need to be configured as Master and Slave
to function properly.
Set the jumper setting to SLAVE position on the additional HDD.
Install the additional HDD in the space as shown on Fig. 9-1.
Connect the power connector and the flat cable to the HDD.
Reassemble the cover.
Turn on the system and choose SETUP-SYSTEM-HARD DISK to confirm that the
system recognizes the additional HDD. If the system fails to recognize the HDD,
check for correct jumper settings and secure cable connections.
check for correct jumper settings and secure cable connections.
Note. Be sure that the jumper setting is correct. If not, the system
will not recognize the additional HDD.