Руководство По Установке для Nortel 4000
Nautica BRI-ST/BRI-U Module
300275-D Rev. 00
2-5
Figure 2-4.
Positioning the BRI Module
6.
Close the Nautica 4000 (see Chapter 1).
7.
The BRI-ST module requires the use of an NT1 for
proper network termination of the ISDN line. Connect
the ISDN cable from the BRI-ST module to the NT1
connector labelled S/T. In North America, if you have a
stand alone NT1, you require another cable from the
NT1 U connector directly to the ISDN wall socket.
proper network termination of the ISDN line. Connect
the ISDN cable from the BRI-ST module to the NT1
connector labelled S/T. In North America, if you have a
stand alone NT1, you require another cable from the
NT1 U connector directly to the ISDN wall socket.
8.
Turn on the unit.
Using the BRI Module
The BRI module is automatically detected by the Nautica 4000.
Configuration can be performed using either the NauticaRS
software or Nautica Wizard. For more information about these
software packages, refer to the relevant online documentation.
Configuration can be performed using either the NauticaRS
software or Nautica Wizard. For more information about these
software packages, refer to the relevant online documentation.