Release Note для Nortel 4000
300115-B Rev. A
Remote Access Software Version 5.3 Release Notes
96
command: read annex.param
setting annex parameters
setting parameters for async port 1
setting parameters for async port 2
setting parameters for async port 3
setting parameters for async port 4
setting parameters for async port 5
setting parameters for async port 6
setting parameters for async port 7
setting parameters for async port 8
setting parameters for interface en0
setting parameters for interface asy1
setting parameters for interface asy2
setting parameters for interface asy3
setting parameters for interface asy4
setting parameters for interface asy5
setting parameters for interface asy6
setting parameters for interface asy7
setting parameters for interface asy8
command: quit
Using monitor Mode to Provide an IP Address for a New Unit
If you are configuring a new RAC, you must use the monitor prompt to
assign an IP address to the RAC. You need the following equipment to
do this:
assign an IP address to the RAC. You need the following equipment to
do this:
•
A terminal (VT100, laptop, etc.).
•
A straight-through RJ45 cable.
•
A console terminal adapter. If you are using a laptop, you
typically need a DB25 to DB9 converter, straight-through.
typically need a DB25 to DB9 converter, straight-through.