Руководство Пользователя для Nortel 4000
A-89
Appendix A RAC Parameters
Managing Remote Access Concentrators Using Annex Manager
rip_sub_advertise
controls whether the RAC advertises subnet routes over the SLIP, PPP, and
Ethernet interfaces.
Ethernet interfaces.
routed
determines whether the RIP routing daemon is enabled. When you enter
enabled
,
the RAC performs active RIP routing only if
option_key
is set to the correct value.
If
option_key
is not set correctly, the RAC performs passive RIP routing when the
daemon is enabled. If you enter
disabled
, no RIP routing occurs.
If you disable the RIP routing daemon and the RAC does not reside
on the same subnetwork as the Annex Manager host, you cannot
contact the RAC after you reboot the RAC or after you reset the
routing subsystem.
on the same subnetwork as the Annex Manager host, you cannot
contact the RAC after you reboot the RAC or after you reset the
routing subsystem.
rts_signal
controls the RTS (Request to Send) signal for the port. Entering a value for an
idle port produces an error condition.
idle port produces an error condition.
If you change the value for this parameter and then reset a port
or reboot a RAC, the parameter returns to its original default value.
Therefore, you must choose
Therefore, you must choose
in the
Reset Parameters
window to prevent the reset process and to use the parameter
values you entered.
values you entered.
Type
Interface
Values
enabled or disabled
Default
disabled
Lists
Enet Port, Async Port, Routing
Type
RAC
Values
enabled or disabled
Default
enabled
Lists
RAC Only, Basic RAC, Routing
Cancel
Type
Async
Values
unknown, high, low
Default
unknown
Lists
Async Port