Инструкции По Установке для Nortel 100

Appendix A Network support

Installing the BayStack Instant Internet Management Software Version 7.11

You must configure your BootP or DHCP server to identify the Instant Internet 
unit by its MAC address so that you can assign an IP address to Instant Internet. 
Following is the general procedures to follow when assigning a permanent IP 
address to Instant Internet. For detailed instructions, refer to your system’s 
documentation.

To assign a static IP address to Instant Internet using an existing BootP or DHCP 
server:

Determine the Instant Internet unit’s serial number.

The serial number is on a sticker on the back of the unit.

Translate this number to the unit’s MAC address according to the information 
in 

For example, the serial number I02001234 has the MAC address of 
00:00:81:F2:12:34; the serial number I500E07BF224BB has the MAC 
address of 00:E0:7B:F2:24:BB.

From your BootP or DHCP server’s range of IP addresses, choose an 
IP address for your new Instant Internet unit.

This IP address is the static IP address for the Instant Internet unit.

Map the selected IP address to the Instant Internet’s MAC address on the 
DHCP server.

Table 3   MAC address translation

I01xxxxxx

00:C0:11:xx:xx:xx

I0200xxxx

00:00:81:F2:xx:xx

I0300xxxx

00:00:81:F3:xx:xx

I4xxxxxxxxxxxx

xx:xx:xx:xx:xx:xx

I5xxxxxxxxxxxx

xx:xx:xx:xx:xx:xx