Инструкции По Установке для Nortel 100
83
Installing the BayStack Instant Internet Management Software Version 7.11
Appendix B
Workstation support
Workstation support
Before you install the Instant Internet software on each workstation, you must
prepare each workstation to make sure it can take advantage of the services that
Instant Internet offers. This appendix describes how to prepare IP and IPX
workstations for the Instant Internet software.
prepare each workstation to make sure it can take advantage of the services that
Instant Internet offers. This appendix describes how to prepare IP and IPX
workstations for the Instant Internet software.
Preparing a workstation using IPX
If your workstations use IPX, you must install the workstation Instant Internet
software on each IPX workstation.
software on each IPX workstation.
Preparing a workstation with TCP/IP
Configuring TCP/IP is platform- and system-dependent. These procedures
provide some general guidelines for configuring a workstation with TCP/IP.
Refer to your system’s documentation for proper installation and configuration
instructions.
provide some general guidelines for configuring a workstation with TCP/IP.
Refer to your system’s documentation for proper installation and configuration
instructions.
To configure a workstation with TCP/IP, you must do both of the following:
•
If TCP/IP is not already installed, you must install it on each workstation.
Refer to
Refer to
,” next.
•
Configure the TCP/IP settings by doing one of the following:
— Let the workstations know that Instant Internet will be the gateway and
DNS proxy (
).
— Let the workstations know that Instant Internet will assign IP addresses
(
) and that it has a new address for them (
).