Руководство По Работе для Lowrance 5300c igps

20 

Holes in the bracket's base allow wood screw or through-bolt mounting. 

You may need to place a piece of plywood on the back side of thin fiber-

glass panels to reinforce the panel and secure the mounting hardware. 

 

Drill a 1-inch (25.4 mm) hole in the dash for the power cable. The best 

location for this hole is immediately under the gimbal bracket location. 

This way, the bracket can be installed so that it covers the hole, holds 

the cables in position and results in a neat installation. Some custom-

ers, however, prefer to mount the bracket to the side of the cable hole 

— it's a matter of personal preference. 

 

 

After drilling the hole, pass the power cable's bare-wire end down 

though the hole from the top.