Руководство По Работе для Lowrance lms-334c igps

150

The GPS Simulator menu.

Adjust the settings to your preferences, then turn on the simulator by
highlighting the 

 box and pressing 

. Press 

re-

peatedly to close the menu. A message and tone appear periodically,
warning you the simulator is on. To turn off the simulator, repeat the
steps above or turn off the unit.

While in simulator mode, you can press 

 to clear the steering and

speed boxes from the screen while continuing the simulation. This will
allow you to use the map cursor when running the simulator. To turn
on the steering and speed boxes again, return to the GPS Simulator
menu, select the 

 command and press 

. Press 

repeatedly to get back to the main page display.

Simulating Trail or Route Navigation

To automatically follow a trail or route without manual steering:

1. From the Map Page, go to the simulator menu. Pick a 

 at or near the beginning of your trail/route. Enter an approximate

 (shown in compass degrees) that will point you toward the start

of the trail/route.

2. Set 

 to zero. Select 

 command and press 

,

which turns on the simulator and returns you to the Map Page.

3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press 

 to clear the alarm.) When navigation starts,

press 

↑ to increase speed to the desired setting.

4. Press 

 to turn off the steering and speed boxes. The unit will now

automatically "steer" along the trail or route. When you arrive at your
"destination," cancel navigation as you normally do.