Руководство По Работе для Lowrance lms-520c

18 

B. Two-piece bracket: Locate the four plastic ratchets in the trans-

ducer's hardware package. Press two ratchets into the sides of the plas-

tic bracket and two on either side of the transducer as shown in the fol-

lowing illustrations. Notice there are letters molded into each ratchet. 
Place the ratchets into the bracket with the letter "A" aligned with the 

alignment mark molded into the bracket. Place the ratchets onto the 

transducer with the letter "A" aligned with the 12 o'clock position on 

the transducer stem. These positions set the transducer's coarse angle 
adjustment for a 14

° transom. Most outboard and stern-drive transoms 

have a 14

° angle. 

 

 

 

A. One-piece bracket: Slide the transducer between the two ratch-

ets. Temporarily slide the bolt though the transducer assembly and