Руководство По Работе для Lowrance lms-520c

32 

If possible, keep the power cable away from other boat wiring, especially 

the engine's wires. This will provide the best isolation from electrical 

noise. If the cable is not long enough, splice #18 gauge wire onto it. 
The display power cable has three wires, white, red and black. Red is the 

positive (+) lead, black is negative (–) or ground. The white wire is un-

used by your unit and should be capped. Make sure to attach the in-line 
fuse holder to the red lead as close to the power source as possible. 
For example, if you have to extend the power cable to the power bus or 

battery, attach one end of the fuse holder directly to the power bus or 

battery. This will protect both the unit and the power cable in the event 

of a short. 
This unit has reverse polarity protection. No damage will occur if the 

power wires are reversed. However, the unit will not work until the 

wires are attached correctly. 

 

The network and any NMEA 2000 devices, including the GPS 
module,  will not operate unless the NMEA 2000 Power Cable is 

connected to power. The NMEA 2000 power cable must be connected