Дополнительное Руководство для Extreme 3804
Minimal Operation Mode
Advanced System Diagnostics and Troubleshooting Guide
105
To detect a reboot loop, a timestamp and a counter are saved. Each time the switch reboots because of a
software crash or exception, the counter is incremented. A user-executed
software crash or exception, the counter is incremented. A user-executed
reboot
command clears the
timestamp and counter to prevent a false reboot loop protection. This action also allows the user to
bring the switch out of minimal operation mode so that the system can come up normally after the
failure has been identified and fixed.
bring the switch out of minimal operation mode so that the system can come up normally after the
failure has been identified and fixed.
Bringing a Switch Out of Minimal Operation Mode
To bring a switch out of minimal operation mode, perform these steps:
1
Begin collecting background information that might help isolate the causes of the problem and
contact Extreme Networks technical support and notify them about the problem.
contact Extreme Networks technical support and notify them about the problem.
a
Note any recent hardware or configuration changes.
b
Create a detailed description of all the known symptoms.
c
Capture the output from the
show log
command.
d
Capture the output from the
show diagnostics
command.
e
On a sheet of paper, write down the state of all LEDs on the switch.
2
Use the
clear log diag-status
command to clear the hardware error codes.
3
Use the
reboot
command to reboot the system.
4
Use the show tech CLI command to collect system information.
5
Send all of the information about the problem to Extreme Networks technical support.