Краткое Руководство По Установке для Intermec 2410

C d 39 nuggetfont

 

Before you can use the 2415, you must install and configure the 
host and access points. You may also need to install and 
configure the Intermec Gateway or DCS 30X. Depending on 
your network protocol, the 2415 can communicate with a host 
computer either through access points and the Intermec 
Gateway or DCS 30X (UDP Plus or WTP network) or directly 
through the access points (TCP/IP network). 

Press ( \ 2 4 8 to access the TRAKKER Antares  
2400 Menu System. Choose Configuration Menu > 
Communications Menu > Primary Network or Advanced 
Network. You need to obtain most of these settings from your 
network administrator. 

 

Note: If you are using the WTP network, you only 
need to configure the Primary Network parameters. 

Make sure that 2.4 GHz RF (OpenAir radio) or 802.11 DS 
(802.11b radio) appears in the Activate field. 

If you are using the WTP network, you only need to 
configure the Activate field. 

 (UDP Plus) In the Controller IP Address field, enter the IP 
address of the Intermec Gateway or DCS 30X in your 
network. The IP address must be in the form n.n.n.n, where 
each n is a number from 0 to 255. You must separate each n 
by a period. 

(TCP/IP) In the Host IP address field, enter the IP address 
of the host that you want the terminal to communicate with. 
The IP address must be in the form n.n.n.n, where each n is a 
number from 0 to 255. You must separate each n by a period. 

In the Terminal IP Address field, enter the IP address of the 
terminal. The IP address must be in the form n.n.n.n, where 
each n is a number from 0 to 255. You must separate each n 
by a period.