Справочное Руководство для Intermec 9710
Wyse 50
C d 39
94
Wyse 50
This section covers the Wyse 50 workstation. The individual Wedge Interface Guide
corresponding to this section is part number 055942.
corresponding to this section is part number 055942.
Cables
Connecting the reader to the Wyse 50 workstation requires one cable. The interface kit
contains the keyboard/terminal cable. If you need to order a replacement cable, use the
part numbers listed below:
contains the keyboard/terminal cable. If you need to order a replacement cable, use the
part numbers listed below:
• Wedge interface kit (P/N 055941)
• Keyboard/Terminal cable (P/N 055939)
• Keyboard/Terminal cable (P/N 055939)
Power Supply
The reader does not require an external power supply to work with the workstation. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan this label to configure the reader for your workstation. After the label is scanned,
the reader emits one low beep followed by four low beeps. The four low beeps indicate
the reader has successfully stored the configuration and is ready to read labels. If the
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
the reader emits one low beep followed by four low beeps. The four low beeps indicate
the reader has successfully stored the configuration and is ready to read labels. If the
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
Wyse 50
*$+TA74*
*$+TA74*