Справочное Руководство для Intermec 9710
C d 39
Unisys 1224
89
Unisys 1224
This section covers the Unisys 1224 workstation. The individual Wedge Interface Guide
corresponding to this section is part number 054340.
corresponding to this section is part number 054340.
Cables
Connecting the reader to the this workstation requires two cables: a keyboard cable and
a terminal cable. The interface kit contains both the keyboard and terminal cables. If
you need to order a replacement cable, use the part numbers listed below:
a terminal cable. The interface kit contains both the keyboard and terminal cables. If
you need to order a replacement cable, use the part numbers listed below:
• Wedge interface kit (P/N 054339)
• Keyboard cable (P/N 054338)
• Terminal cable (P/N 054337)
• Keyboard cable (P/N 054338)
• Terminal cable (P/N 054337)
Power Supply
The reader does not require external power to work with this workstation. Set the PCB
jumper to connect pins 1 and 2 on the reader’s rear panel.
jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
US Keyboard
*$+TA192*
*$+TA192*
Danish Keyboard
*$+TA226*
*$+TA226*
Dutch Keyboard
*$+TA230*
*$+TA230*
Finnish Keyboard
*$+TA228*
*$+TA228*