Справочное Руководство для Intermec 1800
Flashing mode
SP/XX/RM/10/E/960401
43
Flashing mode
To increase LED life, the ScanPlus is configured by default to flash after 10 minutes in
standby instead of producing a continuous beam. When you present a bar code, it will
return to a continuous beam.
standby instead of producing a continuous beam. When you present a bar code, it will
return to a continuous beam.
Flashing mode is the default mode for all ScanPlus models but is not available when
the pushbutton of pushbutton models is activated.
the pushbutton of pushbutton models is activated.
Flash After 10 Minutes (*)
No Flash
Compose flash time-out
Compose Time-Out Before Flash
(1-minute increments, max = 60 minutes)
(1-minute increments, max = 60 minutes)
Example
To make your ScanPlus start to flash after 30 minutes of inactivity:
1. Scan Compose Time-Out Before Flash.
2. Scan 3
0
then scan End Selection (
Ð
Number codes
or inside
back cover of this manual).