Руководство Пользователя для Citel 1100

 Guide 

This chapter discusses the basic information on connecting and disconnecting the 
Extender session from the 1100A Remote 1100A module to the 1100A Switch Module. 

1.  Exit the Telephone Management Interface phone menu.  Press 1 (Prv) key until you 

return to the “Exit Admin Menu”, then Press 2 (OK) 

2.  “Connect, Press 1” menu should be displayed. 

3.  Press 1 to initiate the connection. 

4.  If User ID is not configured you will be prompted to enter a User ID.  Enter it now (1 is 

the default ID). 

5.  The Office phone number is then dialed and the modules will connect.  The 

connection process will take around 20 seconds during this time the phone will display 
connection status messages “Connecting”, “Ringing”, and finally “Modem syncd”. 

6.  If configured you may be prompted to enter a password.  If password is valid a 

“Password OK” message will be displayed. 

The phone will initialize (this time varies based on PBX Type).  Once you see the time and 
date on your phone LCD display initialization is complete and your phone is Extended 
ready to make and receive calls. 

1.  First end all active calls on your phone. 

2.  Access the online Telephone Management Interface phone menu by pressing the 

‘HOLD’ key four times. 

3.  The phone should display “Disconnect” 

4.  Press 2 (OK) to disconnect, or Press 3 (Next) to be prompted to Re-Connect to 

Extender Session. 

5.  If you Press 2 a “Discon Sequence” message will be displayed on the LCD and then 

Remote LCD should return to the “Connect, Press 1” menu. 

The Remote module is now no longer connected to the Switch module, the Extender 
Session is disconnected.