Руководство Пользователя для Peavey triple xxx
(1)
POWER SWITCH
This two-way toggle switch applies mains power to the unit. The red POWER STATUS LAMP
(3) will illuminate when this switch is in the ON position.
This two-way toggle switch applies mains power to the unit. The red POWER STATUS LAMP
(3) will illuminate when this switch is in the ON position.
(2)
STANDBY SWITCH
This two-way toggle switch allows the amp to be placed in the STANDBY mode. In the
STANDBY position the tubes stay hot but the amplifier is not operational. Switching to the ON
position places the amp in active mode.
This two-way toggle switch allows the amp to be placed in the STANDBY mode. In the
STANDBY position the tubes stay hot but the amplifier is not operational. Switching to the ON
position places the amp in active mode.
(3)
POWER STATUS LAMP
This indicator illuminates when mains power is being supplied to the amp.
This indicator illuminates when mains power is being supplied to the amp.
(4)
MASTER VOLUME
This control sets the overall volume level of the amp. Once the desired balance between the
three channels in the amplifier has been achieved, the entire output level of the unit can be
increased or decreased by rotating this control. Clockwise rotation increases level;
counterclockwise rotation decreases level.
This control sets the overall volume level of the amp. Once the desired balance between the
three channels in the amplifier has been achieved, the entire output level of the unit can be
increased or decreased by rotating this control. Clockwise rotation increases level;
counterclockwise rotation decreases level.
(5)
HAIR
This control, on both the Ultra and Crunch channels, varies the high frequency response of
the amplifier. It is an active control (shelving type) and allows 15 dB of boost or cut.
This control, on both the Ultra and Crunch channels, varies the high frequency response of
the amplifier. It is an active control (shelving type) and allows 15 dB of boost or cut.
(6)
BODY
This control, on both the Ultra and Crunch channels, varies the mid frequency response of
the amplifier. It is an active control (peak/notch type) and allows 15 dB of boost or cut.
This control, on both the Ultra and Crunch channels, varies the mid frequency response of
the amplifier. It is an active control (peak/notch type) and allows 15 dB of boost or cut.
(7)
BOTTOM
This control, on both the Ultra and Crunch channels, varies the low frequency response of the
amplifier. It is an active control (shelving type) and allows 15 dB of boost or cut.
This control, on both the Ultra and Crunch channels, varies the low frequency response of the
amplifier. It is an active control (shelving type) and allows 15 dB of boost or cut.
(8) VOLUME
This control, on all three channels, sets the overall level of its respective channel.
FRONT PANEL
1
2
4
3
6
5
8
7
9
11
12
13
14
15
10
8
4