Руководство Пользователя для Acer 3700gx
75
Frequently asked questions
The following questions are possible situations that may arise during the use
of your computer and each is followed by easy answers and solutions to the
situation.
of your computer and each is followed by easy answers and solutions to the
situation.
Q: I pressed the power switch but the system did not boot up.
A: Check the LED located above the power switch.
If the LED is not lit, no power is being applied to the system. Try the following:
•
•
Check if the voltage selector switch located on the rear panel of the
computer is set to the correct voltage.
computer is set to the correct voltage.
•
Check if you plugged the power cable properly into an electrical outlet.
•
If you are using a power strip or AVR, make sure that it is plugged in and
turned on.
turned on.
If the LED is lit, check the following:
•
•
Is a nonbootable (nonsystem) diskette in the floppy drive? If yes, remove
or replace it with a system diskette and press Ctrl + Alt + Del to restart
your computer.
or replace it with a system diskette and press Ctrl + Alt + Del to restart
your computer.
•
The operating system files may be damaged or missing. Insert the startup
disk you created during Windows setup into the floppy drive and press
Ctrl + Alt + Del to restart your computer. This will automatically diagnose
your system and make necessary fixes. However, if the diagnostic utility
still reports a problem, then you may have to perform the recovery
process to restore your system to its original default factory settings.
disk you created during Windows setup into the floppy drive and press
Ctrl + Alt + Del to restart your computer. This will automatically diagnose
your system and make necessary fixes. However, if the diagnostic utility
still reports a problem, then you may have to perform the recovery
process to restore your system to its original default factory settings.
Note: For more information about recovering your system, refer
to page 70.
to page 70.
Q: Nothing appears on the screen.
A: Your computer’s power management function automatically blanks the
screen to save power. Just press any key to turn the display back on.
screen to save power. Just press any key to turn the display back on.
If pressing a key does not work, you can restart your computer. If restarting
your computer does not work, contact your dealer or the technical support
center for assistance.
your computer does not work, contact your dealer or the technical support
center for assistance.
Q: The printer does not work.
A: Do the following: