Руководство Пользователя для Revel sub15
PLACEMENT (Continued)
LE-1 PLACEMENT
In a normal installation, the ULTIMA LE-1 receives its signals
from the preamplifier’s main output jacks and sends its signals (via
an internal crossover) to the ULTIMA SUB-15. To use the shortest
interconnect cables, place the ULTIMA LE-1 near the amplifier.
However, in doing so, please observe the following:
from the preamplifier’s main output jacks and sends its signals (via
an internal crossover) to the ULTIMA SUB-15. To use the shortest
interconnect cables, place the ULTIMA LE-1 near the amplifier.
However, in doing so, please observe the following:
•
To help dissipate internal heat, provide the ULTIMA LE-1
with adequate ventilation. Do not enclose the unit in an
unvented cabinet. Allow a minimum clearance of 4 to 6 inches
above the ULTIMA LE-1 and at least 2 inches on either side
for air flow.
with adequate ventilation. Do not enclose the unit in an
unvented cabinet. Allow a minimum clearance of 4 to 6 inches
above the ULTIMA LE-1 and at least 2 inches on either side
for air flow.
•
Place the ULTIMA LE-1 so its front panel is readily accessible
for viewing and control with the enclosed remote control.
for viewing and control with the enclosed remote control.
•
Provide convenient access to the ULTIMA LE-1’s rear panel to
allow for easy interconnection and later adjustment of system
controls (see System Optimization on page 25).
allow for easy interconnection and later adjustment of system
controls (see System Optimization on page 25).
NOTE: Be sure to use adequate speaker cables to connect the
ULTIMA LE-1 and SUB-15(s). As an aid in determining the
maximum wire length for any gauge of speaker cable, please see
Figure 9 on page 18.
ULTIMA LE-1 and SUB-15(s). As an aid in determining the
maximum wire length for any gauge of speaker cable, please see
Figure 9 on page 18.
ULTIMA SUB-15/LE-1
Owner’s Manual
12