Справочник Пользователя для Panasonic aj-sdx900

74

Lights for 90 minutes following the release of the
condensation detection after the condensation
formation was detected.

“HUMID” display lights if condensation is
detected.
“HUMID” display flashes for an additional 10 to 90
minutes after condensation detection is canceled.

Flashes 4 times per second for 90 minutes after
condensation detection is canceled.

“HUMID” display flashes from the time
condensation is detected until 90 minutes after
the condensation detection is released.

Sounds continuously (4 times a second during
recording).

Condensation has formed.

The recording operation continues but if the tape
sticks, recording will stop.
For 80 minutes after the condensation detection is
released, the drum is rotated and no operations
are accepted.

Stop the tape travel and turn off the power.  If the
“HUMID” displays fails to be cleared even when
the power is turned back on, wait until it clears.

Flashes four times a second (during recording
and playback).

“SERVO” display lights (during recording and
playback).

Flashes four times a second (during recording
and playback).

“SERVO” display lights (during recording and
playback).

Sounds four times a second (during recording and
playback).

The servo is disturbed.

Operation continues but the unit may not operate
correctly.

Turn off the power and consult your dealer.  The
warning display may flash for a moment and then
disappear when tape transport commences: this
is normal and not indicative of a failure or
malfunctioning.

Flashes four times a second (during recording).

“RF” display flashes (during standby and recording).

Flashes four times a second (during recording).

“RF” display lights (during recording).

Sounds four times a second (during recording).

The video heads have become clogged.  There is
a problem in the video system.

The cleaning rollers are activated to clean the
heads (for a maximum of 3 seconds).
Recording continues but the signals may not be
recorded correctly.
The indications on LCD screen are retained until
the REC/PAUSE status is established.  They go
off as soon as the unit transfers from the
REC/PAUSE mode to another mode.

Clean the heads.  If the signals cannot be
recorded correctly even after cleaning, consult
your nearest service center.

Flashes four times a second (during standby and
recording).

No indication

Flashes four times a second (during recording).

“WIRELESS RF” display lights for at least 3
seconds during recording.

Sounds four times a second (for at least 3
seconds during standby and recording).

Poor wireless signal reception.

Operation continues but the signals from the
wireless microphone cannot be received.

Check the microphone’s power supply and the
reception condition of the receiver.

Flashes once a second (during recording).

The bar display that shows the remaining tape
amount starts flashing.

Flashes once a second (during recording).

≥

The remaining tape display starts flashing (in
the EE mode).

≥

“

=” flashes for 3 seconds one minute before

the tape reaches the end.

Sounds once a second.

The tape is close to its end (about 2 minutes
remain).

Operation continues.

Replace the cassette tape when it becomes
necessary.

Flashes once a second.

The bar display that shows the remaining battery
charge starts flashing.

Flashes once a second.

BATT LED starts flashing.

Sounds four times a second.

The battery charge is nearly depleted.

Operation continues.

Replace the battery when it becomes necessary.