Справочник Пользователя для Panasonic aj-spc700

96

All 7 bar indicators for remaining MEDIA
capacity start blinking. 

Continues to light up until an operation is
performed. 

Continues to blink 4 times per second until
an operation is performed. 

The END indicator blinks. 

Continues to beep until an operation is
performed. 

The P2 cards are recorded to maximum
capacity. 

The recording stops. 

Delete the clips in the P2 card or insert a
new P2 card. 

No display. 

Blinks 4 times per second. (During pause
and recording) 

Blinks 4 times per second while recording
continues. 

The WIRELESS RF indicator lights up while
recording continues. 

Beeps 4 times per second while recording
continues. 

This error indicates poor wireless audio
reception conditions. 

Continues to operate without receiving the
wireless microphone signal. 

Check the microphone power supply and the
reception status of the wireless receiver. 

“00:00:00:11” appears in the time code
display field. Even after recording is stopped,
this display continues to blink until the next
operation is performed.

Blinks 4 times per second while recording
continues. 

Blinks 4 times per second while recording
continues. 

The REC WARNING indicator lights up. 

Beeps 4 times per second while recording
continues. 

This indicates a failure either in the P2 card
recording or the recording circuit.

Recording stops. 

Restart recording. Or, turn the power OFF
and turn it ON again, before starting
recording. 

The 1394 E-

__ indicator in the display

window lights up.

Blinks 4 times per second while the
WARNING lamp recording is continuing.

Blinks 4 times per second while the TALLY
LAMP recording is continuing.

In the case of Error Code 92, “1394 INITIAL
ERROR” indicator lights up (during pause
and recording)
For Error Codes other than Error Code 92, or
if REC SIGNAL is set to “1394”, no error is
displayed in the viewfinder.

Beeps 4 times per second while ALARM
recording is continuing.

This indicates a failure of the DVCPRO/DV
connector.

The operation continues, but input signals to
the DVCPRO/DV connector are abnormal.

Check the connection between the
IEEE1394 cable and the DVCPRO/DV
connector, settings of any external device
and menus, and the turn on the power again.
If the warning indication is still illuminated,
confirm the “Error Codes” in the IEEE1394
interface board instruction manual, and
consult your distributor.

#,52%2 'PINKUJDQQMࡍ࡯ࠫ㧞㧜㧜㧢ᐕ㧡᦬㧝㧝ᣣޓᧁᦐᣣޓඦ೨㧥ᤨ㧠㧡ಽ