Инструкции По Установке для Whirlpool WED6200S

4. Using pliers, tighten the couplings with an additional two-thirds 

turn. 

NOTE: Do not overtighten. Damage to the coupling can result.

5. Attach “Y” connector to brass male end of small hose. Screw on 

coupling by hand until it is seated on connector.

6. Attach straight end of long hose to “Y” connector.

7. Attach washer cold inlet hose to other end of “Y” connector. 

Screw on coupling by hand until it is seated on connector.

8. Using pliers, tighten the couplings an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

9. Attach angled end of long hose to fill valve at bottom of dryer 

back panel. Screw on coupling by hand until it is seated on fill 
valve connector. 

10. Using pliers, tighten the coupling an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the coupling can result.

11. Check that the water faucets are on.

12. Check for leaks around “Y” connector, faucet, and hoses. 

Check the levelness of the dryer by first placing a level on the top 

 

of the dryer near the console.  

Then, by placing a level in the crease on the side of the dryer 
between the top of the dryer and the dryer cabinet, check 

 

the levelness from front to back.

If the dryer is not level, prop up the dryer using a wood block. Use a 
wrench to adjust the legs up or down and check again for levelness.

1. Check that all parts are now installed. If there is an extra part, 

 

go back through the steps to see which step was skipped.

2. Check that you have all of your tools.
3. Dispose of/recycle all packaging materials. 
4. Check the dryer’s final location. Be sure the vent is not crushed 

 

or kinked.

5. Check that the dryer is level. See “Level Dryer.”
6. Remove the blue film on the console and any tape remaining on 

the dryer.

7. Wipe the dryer drum interior thoroughly with a damp cloth to 

remove any dust.

8. Read “Dryer Use” in your Use and Care Guide.
9. For power supply cord installation, plug into a grounded outlet. 

For direct wire installation, turn on power.

10. Be sure the water faucets are on.

11. Check for leaks around “Y” connector, faucet, and hoses.

12. If you live in a hard water area, use of a water softener is 

recommended to control the buildup of scale through the water 
system in the dryer. Over time, the buildup of lime scale may clog 
different parts of the water system, which will reduce product 
performance. Excessive scale buildup may lead to the need for 
certain part replacement or repair.