Техническое Руководство для Wolf 315w

Unless you are installing a stainless steel unit, you will

need to provide a door panel frame, where wine will be

seen from the outside. If you order a stainless steel unit,

the Model 315W will be shipped with the panel and

hardware installed and you will merely install the Sub-Zero. 

The door frame of the unit has pre-drilled holes for our

optional handle hardware. Refer to Hardware Considera-

tions on page 8 for specifics about installing handle

hardware on this overlay application.

The overlay panel applied to Model 315W should not be

confused with the Built-In overlay panel application. The

overlay panel will consist of only a frame and would be

either the 

5

/

8

" (16) or 

3

/

4

" (19) panel you may be using. It is

affixed directly to the door itself with screws through a

series of pre-drilled holes in the perimeter of the door

itself. You do not need any backer or spacer panel.

The glass door opening of the Model 315W is designed to

be exposed to room air circulation. Decorative overlays on

the glass should be kept to a minimum. Also, rails and

stiles can be increased in size but should not exceed

cabinet manufacturers standard width. They cannot

exceed overall door panel dimensions specified, as they

would interfere with the operation of the door. The back

sides of rails and stiles that will be visible through the

glass door will need to be finished. Also, the inside edges

of the frames must be finished to match the front surface.