Инструкция для Sony cdx-gt42ipw

Скачать
Страница из 36
14
About iPod
This unit can be used with the dock connector type 
iPod, iPod photo, iPod mini and iPod nano with the 
following software versions. All other versions 
earlier than listed are not guaranteed.
– Third-generation iPod: Ver.2.3.0
– Fourth-generation iPod: Ver.3.1.1
– Fifth-generation iPod: Ver.1.2
– iPod photo: Ver.1.2.1
– iPod mini: Ver.1.4.1
– First-generation iPod nano: Ver.1.3
– Second-generation iPod nano: Ver.1.1
(video function of fifth-generation iPod and 
photo function of iPod photo are not supported).
For customers in USA, please visit the following 
site for further information: 
http://www.xplodsony.com
If you have any questions or problems concerning 
your unit that are not covered in this manual, consult 
your nearest Sony dealer.
Maintenance
Replacing the lithium battery of the 
card remote commander
Under normal conditions, the battery will last 
approximately 1 year. (The service life may be 
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the 
card remote commander becomes shorter. Replace 
the battery with a new CR2025 lithium battery. Use 
of any other battery may present a risk of fire or 
explosion.
Notes on the lithium battery
• Keep the lithium battery out of the reach of children. 
Should the battery be swallowed, immediately 
consult a doctor.
• Wipe the battery with a dry cloth to assure a good 
contact.
• Be sure to observe the correct polarity when 
installing the battery.
• Do not hold the battery with metallic tweezers, 
otherwise a short-circuit may occur.
Fuse replacement
When replacing the fuse, be 
sure to use one matching the 
amperage rating stated on the 
original fuse. If the fuse blows, 
check the power connection and 
replace the fuse. If the fuse 
blows again after replacement, 
there may be an internal 
malfunction. In such a case, 
consult your nearest Sony 
dealer.
Cleaning the connectors
The unit may not function properly if the connectors 
between the unit and the front panel are not clean. In 
order to prevent this, detach the front panel (page 5) 
and clean the connectors with a cotton swab. Do not 
apply too much force. Otherwise, the connectors 
may be damaged.
Notes
• For safety, turn off the ignition before cleaning the 
connectors, and remove the key from the ignition 
switch.
• Never touch the connectors directly with your fingers 
or with any metal device.
Removing the unit
1
Remove the protection collar.
1
Detach the front panel (page 5).
2
Engage the release keys together with the 
protection collar.
1
2
+ side up
c
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of
in fire.
Fuse (10A)
Main unit
Back of the front 
panel
Orient the release 
keys as shown.