Справочное Руководство для 3com 8807
RIP Configuration Commands
405
To enter the RIP view to configure various RIP global parameters, RIP should be
enabled first. Whereas the configuration of parameters related to the interfaces is
not restricted by enabling/disabling RIP.
enabled first. Whereas the configuration of parameters related to the interfaces is
not restricted by enabling/disabling RIP.
n
Note that the interface parameters configured previously would be invalid when
RIP is disabled or reset.
RIP is disabled or reset.
Example
# Enable the RIP and enter the RIP view.
[SW8800] rip
[3Com-rip]
rip authentication-mode
Syntax
rip authentication-mode { simple password | md5 { usual key-string |
nonstandard key-string key-id } }
nonstandard key-string key-id } }
undo rip authentication-mode
View
Interface view
Parameter
simple: Simple text authentication mode.
password: Simple text authentication key. It is a character string of 1 to 16
characters.
characters.
md5: MD5 cipher text authentication mode.
usual: Specifies the MD5 cipher text authentication packet to use the general
packet format (RFC1723 standard format).
packet format (RFC1723 standard format).
key-string: MD5 cipher text authentication key. If it is input in a plain text form,
MD5 key is a character string not exceeding 16 characters. And it will be displayed
in a cipher text form in a length of 24 characters when the display
current-configuration command is executed. Inputting the MD5 key in a cipher
text form with 24 characters long is also supported.
MD5 key is a character string not exceeding 16 characters. And it will be displayed
in a cipher text form in a length of 24 characters when the display
current-configuration command is executed. Inputting the MD5 key in a cipher
text form with 24 characters long is also supported.
nonstandard: Specifies the MD5 cipher text authentication packet to use a
nonstandard packet format described in RFC2082.
nonstandard packet format described in RFC2082.
key-id: MD5 cipher text authentication identifier, ranging from 1 to 255.
Description
Use the rip authentication-mode command to configure RIP-2 authentication
mode and its parameters.
mode and its parameters.
Use the undo rip authentication-mode command to cancel the RIP-2
authentication.
authentication.
RIP-1 does not support authentication. There are two RIP authentication modes:
simple authentication and MD5 cipher text authentication for RIP-2. When MD5
simple authentication and MD5 cipher text authentication for RIP-2. When MD5