Руководство Пользователя для 3com 8807
Typical OSPF Configuration Example
331
Typical OSPF
Configuration
Example
Configuration
Example
Configuring DR Election
Based on OSPF Priority
Network requirements
Four Switch 8800 Family series, Switch A, Switch B, Switch C and Switch D, which
can perform the router functions and run OSPF, are located on the same segment,
as shown in the following figure.
can perform the router functions and run OSPF, are located on the same segment,
as shown in the following figure.
Configure Switch A and Switch C as DR and BDR respectively. The priority of
Switch A is 100, which is the highest on the network, so it is elected as the DR.
Switch C has the second highest priority, that is, 2, so it is elected as the BDR. The
priority of Switch B is 0, which means that it cannot be elected as the DR. Switch D
does not have a priority, which takes 1 by default.
Switch A is 100, which is the highest on the network, so it is elected as the DR.
Switch C has the second highest priority, that is, 2, so it is elected as the BDR. The
priority of Switch B is 0, which means that it cannot be elected as the DR. Switch D
does not have a priority, which takes 1 by default.
View OSPF inter-area route
summarization information
summarization information
display ospf [ process-id ] abr-summary
Display the summary
information of OSPF imported
routes
information of OSPF imported
routes
display ospf [ process-id ] asbr-summary [ ip-address mask ]
Display OSPF interface
information
information
display ospf [ process-id ] interface
Display OSPF errors
display ospf [ process-id ] error
Display OSPF Graceful Restart
information
information
display ospf [ process-id ] graceful-restart status
Display the state of the global
OSPF debugging switches and
the state of the debugging
switches for each process
OSPF debugging switches and
the state of the debugging
switches for each process
display debugging ospf
Enable OSPF packet
debugging
debugging
debugging ospf packet [ ack | dd | hello | interface
interface-type interface-number | request I update ]
interface-type interface-number | request I update ]
Disable OSPF packet
debugging
debugging
undo debugging ospf packet [ ack | dd | hello | interface
interface-type interface-number | request I update ]
interface-type interface-number | request I update ]
Enable OSPF event debugging debugging ospf event
Disable OSPF event debugging undo debugging ospf event
Enable OSPF LSA packet
debugging
debugging
debugging ospf lsa-originate
Disable OSPF LSA packet
debugging
debugging
undo debugging ospf lsa-originate
Enable SPF debugging of
OSPF
OSPF
debugging ospf spf
Disable SPF debugging of
OSPF
OSPF
undo debugging ospf spf
Table 307 Display and debug OSPF
Operation Command