Руководство Пользователя для 3com 2226 PLUS
Rack-Mounting or Free-Standing
15
Using the Mounting Kit
The Switch is supplied with two mounting brackets
and four screws. These are used for rack mounting
the unit. When mounting the unit, take note of the
guidelines given in
and four screws. These are used for rack mounting
the unit. When mounting the unit, take note of the
guidelines given in
The Switch is 1U (1.75 in.) high and will fit in a stan-
dard 19-inch rack.
dard 19-inch rack.
CAUTION: Before continuing, disconnect all cables
from the unit. Remove the self-adhesive pads from
the underside of unit, if already fitted.
from the unit. Remove the self-adhesive pads from
the underside of unit, if already fitted.
To rack-mount the Switch:
1
Place the unit the right way up on a hard, flat surface
with the front facing towards you.
with the front facing towards you.
2
Locate a mounting bracket over the mounting holes
on one side of the unit.
on one side of the unit.
3
Insert the two screws supplied in the mounting kit
and fully tighten with a suitable screwdriver.
and fully tighten with a suitable screwdriver.
Figure 2 Inserting the Screws
4
Repeat the two previous steps for the other side of
the unit.
the unit.
5
Insert the unit into the 19-inch rack and secure with
suitable screws (not provided). Ensure that the venti-
lation holes are not obstructed.
suitable screws (not provided). Ensure that the venti-
lation holes are not obstructed.
6
Reconnect the network cables.
Montagesatz Anweisungen
Der Switch wird mit zwei Halterungen und vier
Schrauben geliefert. Diese werde für den Einbau in
einen Baugruppenträger benutzt. Bei der Montage
der Baugruppe beachten Sie die Anweisungen aus
Schrauben geliefert. Diese werde für den Einbau in
einen Baugruppenträger benutzt. Bei der Montage
der Baugruppe beachten Sie die Anweisungen aus
.
Der Switch ist eine Baueinheit hoch und passt in einen
Standard 19'' (Zoll) Baugruppenträger.
Standard 19'' (Zoll) Baugruppenträger.