Инструкции По Установке для 3com S7906E

 

1-16 

z 

After a BGP peer is configured with the peer connect-interface command, the MTI interface 

automatically obtains the connect-interface  address and uses it as its own IP address. This IP 

address cannot be used in the VPNs network any more; otherwise the MTI interface will fail to 

obtain an IP address. When configuring multiple BGP peers on the same device, you must specify 

the same connect-interface address for these BGP peers; otherwise the MTI interface will also fail 

to obtain an IP address, either. For details about the peer connect-interface command, refer to 

BGP Commands in the IP Routing Volume. 

z 

The MTI interface becomes up only after it obtains an IP address. On S7900E series Ethernet 

switches, in addition, you need first to use the service-loopback group command to configure a 

multicast-tunnel type service loopback group before an MTI interface can be brought up. For 

details about the service-loopback group command, refer to Service Lookback Commands in the 

Access Volume.  

z 

PIM on the MTI interface takes effect only after PIM is enabled on at least one interface of the VPN 

instance; when PIM is disabled on all the interfaces of the VPN instance, PIM on the MTI interface 

is disabled simultaneously.  

 

If PIM-SSM is running in the public network, you need to configure BGP MDT.  

Before configuring BGP MDT, complete the following tasks: 

z 

Configure MPLS L3VPN 

z 

Configure basic BGP functions 

Before configuring BGP MDT, prepare the following data: 

z 

Route reflector cluster ID 

With BGP MDT peers or peer groups configured, a PE exchanges the BGP MDT routing information 

with other PEs to obtain their addresses and thus establish a share-MDT.  

Follow these steps to configure BGP MDT peers or peer groups: 

Enter system view 

system-view 

— 

Enter BGP view 

bgp as-number 

— 

Enter BGP MDT 
sub-address family view 

ipv4-family mdt 

— 

Enable a BGP MDT peer 
or peer group 

peer { group-name | ip-address } 
enable 

Required 

Disabled by default.