Инструкции По Установке для 3com S7906E
1-16
Follow these steps to configure state-refresh parameters:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter IPv6 PIM view
pim ipv6
—
Configure the interval between
state-refresh messages
state-refresh messages
state-refresh-interval interval
Optional
60 seconds by default
Configure the time to wait
before receiving a new
state-refresh message
before receiving a new
state-refresh message
state-refresh-rate-limit
interval
interval
Optional
30 seconds by default
Configure the hop limit value of
state-refresh messages
state-refresh messages
state-refresh-hoplimit
hoplimit-value
hoplimit-value
Optional
255 by default
Configuring IPv6 PIM-DM Graft Retry Period
In IPv6 PIM-DM, graft is the only type of message that uses the acknowledgment mechanism. In an
IPv6 PIM-DM domain, if a router does not receive a graft-ack message from the upstream router within
the specified time after it sends a graft message, the router keeps sending new graft messages at a
configurable interval, namely graft retry period, until it receives a graft-ack from the upstream router.
Follow these steps to configure IPv6 PIM-DM graft retry period:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
interface-number
—
Configure graft retry period
pim ipv6 timer graft-retry
interval
interval
Optional
3 seconds by default
For the configuration of other timers in IPv6 PIM-DM, refer to