Инструкции По Установке для 3com S7906E

 

1-27 

 

Follow these steps to configure the administrative group and affinity attribute: 

Enter system view 

–– 

Enter interface view of MPLS 
TE link  

 interface-type 

 

–– 

Assign the link to a link 
administrative group 

 value 

Optional 
The default is 0x00000000. 

Exit to system view 

–– 

Enter MPLS TE tunnel interface 
view 

 

 

–– 

Configure the affinity attribute 
of the MPLS TE tunnel 

mpls te affinity property 
properties

 [ mask mask-value ]

Optional 
The default affinity attribute is 
0x00000000, and the default 
mask is 0x00000000. 

Submit current tunnel 
configuration 

Required  

 

Dynamic CR-LSP optimization involves periodic calculation of paths that traffic trunks should traverse. If 
a better route is found for an existing CR-LSP, a new CR-LSP will be established to replace the old one, 
and services will be switched to the new CR-LSP. 

Follow these steps to configure CR-LSP reoptimization: 

Enter system view 

–– 

Enter MPLS TE tunnel interface 
view 

 

 

–– 

Enable reoptimization for the 
MPLS TE tunnel 

 

[ frequency seconds ] 

Required 
Disabled by default 

Submit current tunnel 
configuration 

Required 

Exit to user view 

–– 

Perform reoptimization on all 
MPLS TE tunnels with 
reoptimization enabled 

Optional 

 

This section only covers the configuration tasks for tuning MPLS TE tunnel setup.