Инструкции По Установке для 3com S7906E

1-44

------------------------------------------------------------------

LSP Information: STATIC CRLSP

------------------------------------------------------------------

FEC In/Out Label In/Out IF Vrf Name

-/- 20/30 Vlan1/Vlan2

[SwitchC] display mpls lsp

------------------------------------------------------------------

LSP Information: STATIC CRLSP

------------------------------------------------------------------

FEC In/Out Label In/Out IF Vrf Name

-/- 30/NULL Vlan1/-

[SwitchA] display mpls static-cr-lsp

total statics-cr-lsp : 1

Name FEC I/O Label I/O If State

Tunnel0 3.3.3.3/32 NULL/20 -/Vlan1 Up

[SwitchB] display mpls static-cr-lsp

total statics-cr-lsp : 1

Name FEC I/O Label I/O If State

Tunnel0 -/- 20/30 Vlan1/Vlan2 Up

[SwitchC] display mpls static-cr-lsp

total statics-cr-lsp : 1

Name FEC I/O Label I/O If State

Tunnel0 -/- 30/NULL Vlan2/- Up

On an MPLS TE tunnel configured using a static CR-LSP, traffic is forwarded directly based on label at
the transit nodes and egress node. Therefore, it is normal that the FEC field in the sample output is
empty on Switch B and Switch C.

7) Create a static route for routing MPLS TE tunnel traffic.

[SwitchA] ip route-static 3.2.1.2 24 tunnel 0 preference 1

Perform the display ip routing-table command on Switch A. You can find a static route entry with
interface Tunnel 0 as the outgoing interface.

MPLS TE Using RSVP-TE Configuration Example

Network requirements

Switch A, Switch B, Switch C, and Switch D are running IS-IS and all of them are Level-2 devices.

Use RSVP-TE to create a TE tunnel from Switch A to Switch D.