Инструкции По Установке для 3com S7906E

 

11-2 

Displaying and Maintaining Traffic Accounting 

After completing the configuration above, you can verify the configuration with the display qos policy 

global,  display qos policy interface, or display qos vlan-policy command depending on the 

occasion where the QoS policy is applied.  

As shown in 

, Host is connected to GigabitEthernet 2/0/1 of Device.  

Configure class-based accounting to collect statistics for traffic sourced from 1.1.1.1/24 and received 

on GigabitEthernet 2/0/1.  

Figure 11-1 Network diagram for traffic accounting configuration 

 

 

# Create basic ACL 2000, and configure a rule to match packets with source IP address 1.1.1.1.  

<DeviceA> system-view 

[DeviceA] acl number 2000 

[DeviceA-acl-basic-2000] rule permit source 1.1.1.1 0 

[DeviceA-acl-basic-2000] quit 

# Create a class named classifier_1, and reference ACL 2000 in the class.  

[DeviceA] traffic classifier classifier_1 

[DeviceA-classifier-classifier_1] if-match acl 2000 

[DeviceA-classifier-classifier_1] quit 

# Create behavior behavior_1, and configure an accounting action in the behavior.  

[DeviceA] traffic behavior behavior_1 

[DeviceA-behavior-behavior_1] accounting byte 

[DeviceA-behavior-behavior_1] quit 

# Create a policy named policy, and associate class classifier_1 with behavior behavior_1 in the 

policy.  

[DeviceA] qos policy policy 

[DeviceA-qospolicy-policy] classifier classifier_1 behavior behavior_1 

[DeviceA-qospolicy-policy] quit 

# Apply the policy named policy to the incoming traffic of GigabitEthernet 2/0/1.  

[DeviceA] interface gigabitethernet 2/0/1 

[DeviceA-GigabitEthernet2/0/1] qos apply policy policy inbound 

[DeviceA-GigabitEthernet2/0/1] quit