Инструкции По Установке для 3com S7906E

 

2-12 

# Configure to authenticate the user logging in through the Console port in the scheme mode. 

[Sysname-ui-aux0] authentication-mode scheme 

# Set the baud rate of the Console port to 19200 bps. 

[Sysname-ui-aux0] speed 19200 

# Set the maximum number of lines the screen can contain to 30. 

[Sysname-ui-aux0] screen-length 30 

# Set the maximum number of commands the history command buffer can store to 20. 

[Sysname-ui-aux0] history-command max-size 20 

# Set the timeout time of the AUX user interface to 6 minutes. 

[Sysname-ui-aux0] idle-timeout 6 

2) Configure 

the 

authentication scheme 

Configure the authentication server by referring to related parts in AAA Configuration.  

After the above configurations, you need to modify the configurations of the terminal emulation utility 

running on the user PC accordingly, as shown in 

, thus ensuring the consistency between the 

configurations of the terminal emulation utility and those of the switch. Otherwise, you will fail to log in to 

the switch. 

By default, command level for a login user depends on the user level. The user is authorized the 

command with the default level not higher than the user level. With the command authorization 

configured, the command level for a login user is decided by both the user level and AAA authorization. 

If a user executes a command of the corresponding user level, the authorization server checks whether 

the command is authorized. If yes, the command can be executed. 

The authorization server checks the commands authorized for users through the username, and thus 

the command authorization configuration involves three steps: 

1)  Configure to use username and password authentication when users log in. 

2)  Enable command authorization. See the following table for details. 

3)  Configure an authorization scheme. Specify the IP address and other related parameters for the 

accounting server. For details, refer to the AAA Configuration in the Security Volume. 

Follow these steps to enable command authorization: 

Enter system view 

— 

Enter AUX user interface view 

first-number 

[ last-number ] 

— 

Enable command authorization  command authorization 

Required 

Disabled by default, that is, 
users can execute commands 
without authorization.