Инструкции По Установке для 3com S7906E

 

1-5 

Enable sending of 
ICMP timeout 
packets 

Required 

Disabled by default. 

Enable sending of 
ICMP destination 
unreachable packets 

Required 

Disabled by default. 

tracert [ -a source-ip | -f first-ttl | -m max-ttl | 
-p port | -q packet-number | -vpn-instance 
vpn-instance-name | -w timeout ] * host 

Display the routes 
from source to 
destination 

tracert ipv6 [ -f first-ttl | -m max-ttl | -p port | 
-q packet-number | -w timeout ] * host 

Required 

Use either approach 

The tracert command is 
applicable in an IPv4 
network; the tracert ipv6 
command is applicable in an 
IPv6 network. 

Available in any view 

 

For the introduction to the tracert lsp command, refer to MPLS Basics Commands in the MPLS 

Volume. 

 

The device provides various debugging functions. For the majority of protocols and features supported, 

the system provides corresponding debugging information to help users diagnose errors. 

The following two switches control the display of debugging information: 

z 

Protocol debugging switch, which controls protocol-specific debugging information. 

z 

Screen output switch, which controls whether to display the debugging information on a certain 

screen. 

As 

 illustrates, suppose the device can provide debugging for the three modules 1, 2, and 3. 

Only when both the protocol debugging switch and the screen output switch are turned on can 

debugging information be output on a terminal.