Инструкции По Установке для 3com S7906E

 

1-2 

z 

Temporary patches are those not formally released through the version release flow, but 

temporarily provided to solve the emergent problems.  

The common patches always include the functions of the previous temporary patches, so as to replace 

them. The patch type affects the patch loading process only: the system will delete all the temporary 

patches before it loads the common patch. 

Each patch has its status, which can be switched by command lines. The relationship between patch 

state changes and command actions is shown in 

. The patch can be in the state of IDLE, 

DEACTIVE, ACTIVE, and RUNNING. Load, run temporarily, confirm running, stop running, delete, 

install, and uninstall represent operations, corresponding to commands of patch load, patch active, 

patch run, patch deactive, patch delete, patch install, and undo patch install. For example, if you 

execute the patch active command for the patches in the DEACTIVE state, the patches turn to the 

ACTIVE state. 

Figure 1-1 Relationship between patch state changes and command actions 

 

 

Information about patch states is saved in file patchstate on the flash. It is recommended not to operate 

this file.  

 

Patches in the IDLE state are not loaded. You cannot install or run the patches, as shown in 

 

(suppose the memory patch area can load up to eight patches).