Инструкции По Установке для 3com S7906E

 

1-5 

Patches are released per device model or card type. Before patching the system, you need to save the 

appropriate patch files to the storage media of the device using FTP or TFTP. When saving the patch 

files, note that: 

z 

The patch files match the device model and software version. If they are not matched, the hotfixing 

operation will fail. 

z 

Name the patch file properly. Otherwise, the system cannot locate the patch file and the hotfixing 

operation will fail. The name is in the format of "patch_PATCH-FLAG suffix.bin". The 

PATCH-FLAG is pre-defined and support for the PATCH-FLAG depends on device model or card 

type. The first three characters of the version item (using the display patch information command) 

represent the PATCH-FLAG suffix. The system searches the root directory of the storage medium 

(flash by default) for patch files based on the PATCH-FLAG. If there is a match, the system loads 

patches to or install them on the memory patch area.  

 describes the default patch name for each card type. 

Table 1-1 Default patch names for different card types 

mpu PATCH-MPU 

patch_mpu.bin 

lpb PATCH-LPB 

patch_lpb.bin 

S7900E 

lpr PATCH-LPR 

patch_lpr.bin 

 

The loading and installation are performed on all cards that are in position and OAM CPU, so before 

these operations, save the patch files for the active main board (AMB) and interface card to the root 

directory of the AMB's storage medium, and save the patch files for the standby main board (SMB) to 

the root directories of the SMB's storage medium. Make sure the patch files saved on the AMB and 

SMB are the same. 

 

You can use the patch install command to install patches in one step. After you execute the command, 

the system displays the message "Do you want to continue running patches after reboot? [Y/N]:". 

z 

Entering y or Y: All the specified patches are installed, and turn to the RUNNING state from IDLE. 

This equals execution of the commands patch location, patch load, patch active, and patch run. 

The patches remain RUNNING after system reboot. 

z 

Entering n or N: All the specified patches are installed and turn to the ACTIVE state from IDLE. This 

equals execution of the commands patch location, patch load and patch active. The patches 

turn to the DEACTIVE state after system reboot. 

Follow these steps to install the patches in one step: