Инструкции По Установке для 3com S7906E

 

1-23 

1)  Device A and Device B are not connected. Power them on and configure them separately. 

# Configure Device A. 

<Sysname> system-view 

[Sysname] chassis convert mode irf 

This command will convert the device to IRF mode and the device will reboot. Are you sure? 

[Y/N]: y 

The device reboots automatically to switch its operating mode. After logging in to the device again,, 

create IRF-port2 of the device, and bind it to the physical IRF port Ten-GigabitEthernet 1/3/0/25, and 

then save the configurations. 

<Sysname> system-view 

[Sysname] interface ten-gigabitethernet 1/3/0/25 

[Sysname-Ten-GigabitEthernet1/3/0/25] shutdown 

[Sysname-Ten-GigabitEthernet1/3/0/25] quit 

[Sysname] irf-port 1/2 

[Sysname-irf-port 1/2] port group interface ten-gigabitethernet 1/3/0/25 

[Sysname-irf-port 1/2] quit 

[Sysname] interface ten-gigabitethernet 1/3/0/25 

[Sysname-Ten-GigabitEthernet1/3/0/25] undo shutdown 

[Sysname-Ten-GigabitEthernet1/3/0/25] save 

# Configure Device B. 

<Sysname> system-view 

[Sysname] chassis convert mode irf 

This command will convert the device to IRF mode and the device will reboot. Are you sure? 

[Y/N]: y 

The device reboots automatically to switch its operating mode. After logging in to the device again,, 

change the member ID of the device to 2. 

<Sysname> system-view 

[Sysname] irf member 1 renumber 2 

Warning: Renumbering the switch number may result in configuration change or loss. Continue? 

[Y/N]:y 

[Sysname] quit 

<Sysname> reboot 

The device reboots automatically to make the configuration of the member ID take effect. After logging 

in to the device again, create IRF-port1 of the device, and bind it to the physical IRF port 

Ten-GigabitEthernet 2/3/0/25, and then save the configurations. 

<Sysname> system-view 

[Sysname] interface ten-gigabitethernet 2/3/0/25 

[Sysname-Ten-GigabitEthernet2/3/0/25] shutdown 

[Sysname-Ten-GigabitEthernet2/3/0/25] quit 

[Sysname] irf-port 2/1 

[Sysname-irf-port 2/1] port group interface ten-gigabitethernet 2/3/0/25 

[Sysname-irf-port 2/1] quit 

[Sysname] interface ten-gigabitethernet 2/3/0/25