Инструкции По Установке для 3com S7906E

 

1-11 

Follow these steps to configure the monitor port for the remote destination mirroring group in interface 

view: 

Enter system view 

— 

Enter interface view 

interface interface-type 
interface-number 

— 

Configure the current port as 
the monitor port 

[ mirroring-group group-id ] 
monitor-port 

Required 

By default, a port does not 
serve as the monitor port for 
any mirroring group.  

 

z 

A mirroring group contains only one monitor port.  

z 

To ensure that the port mirroring function works properly, do not enable STP, MSTP, or RSTP on 

the monitor port.  

z 

You are recommended to use a monitor port only for port mirroring. This is to ensure that the data 

monitoring device receives and analyzes only the mirrored traffic rather than a mix of mirrored 

traffic and normally forwarded traffic. 

z 

A port connected to an RRPP ring cannot be configured as the monitor port of a port mirroring 

group.  

Follow these steps to configure the remote probe VLAN for the remote destination mirroring group: 

Enter system view 

— 

Configure the remote probe 
VLAN 

mirroring-group group-id 
remote-probe vlan 
rprobe-vlan-id 

Required 

By default, no remote probe 
VLAN is configured for a 
mirroring group. 

 

z 

You are recommended to use the remote probe VLAN for port mirroring exclusively.  

z 

To remove the VLAN configured as a remote probe VLAN, you must remove the remote probe 

VLAN with undo mirroring-group remote-probe vlan command first. Removing the probe VLAN 

can invalidate the remote source mirroring group. 

 

Follow these steps to assign the monitor port to the remote probe VLAN: