Инструкции По Установке для 3com S7906E
5-1
5
Alarm Configuration
Introduction to Alarm
Sampling and Alarms
Sampling means the system retrieves statistics data at the sampling interval
At the alarm monitor interval, the system samples the alarm variables and will trigger an alarm if the
value of a variable exceeds its alarm threshold. Alarm information can be output to the network
management system or alarm buffer by configuring the information center.
value of a variable exceeds its alarm threshold. Alarm information can be output to the network
management system or alarm buffer by configuring the information center.
The alarms can be global alarms, OLT port alarms, or ONU port alarms.
When an alarm configuration command is executed in FTTH view, the command takes effect on all
the OLT ports and all the ONUs attached to the OLT ports.
the OLT ports and all the ONUs attached to the OLT ports.
When an alarm configuration command is executed in OLT port view, the command takes effect on
the current OLT port and all the ONUs attached to the OLT port.
the current OLT port and all the ONUs attached to the OLT port.
When an alarm configuration command is executed in ONU port view, the command takes effect
only on the ONU corresponding to the current ONU port.
only on the ONU corresponding to the current ONU port.
Alarm Configuration Task List
Complete the following tasks to configure alarms:
Task
Remarks
Optional
Optional
Optional
Alarm
configuration
configuration
Optional
Optional
Enabling Alarm Monitoring
Alarm monitoring function takes effect only when statistics sampling function is enabled. This is
because no alarm information can be generated without the average value of sampled statistics.
because no alarm information can be generated without the average value of sampled statistics.
Follow these steps to enabling sampling and alarm monitoring function:
To do...
Use the command...
Remarks
Enter system view
system-view
—
Enter FTTH view
ftth
—