Инструкции По Установке для 3com S7906E
1-6
0.00% packet loss
round-trip min/avg/max = 1/2/4 ms
Dynamic Domain Name Resolution Configuration Example
Network requirements
As shown in
, the IP address of the DNS server is 2.1.1.2/16 and the name suffix is com. The
mapping between domain name host and IP address 3.1.1.1/16 is stored in the com domain.
Dynamic domain name resolution and the domain name suffix are configured on the Switch that serves
as a DNS client, and thus the Switch can use domain name host to access the host with the domain
name host.com and the IP address 3.1.1.1/16.
Figure 1-4 Network diagram for dynamic domain name resolution
Configuration procedure
z
Before performing the following configuration, make sure that the Switch and the host are
accessible to each another via available routes, and the IP addresses of the interfaces are
configured as shown
.
z
This configuration may vary with different DNS servers. The following configuration is performed on
a Windows server 2000 PC.
1) Configure the DNS server
# Enter the DNS server configuration page.
Select Start > Programs > Administrative Tools > DNS.
# Create zone com.
As shown in
, right click Forward Lookup Zones, select New zone, and then follow the
instructions to create a new zone named com.